MY词语>英语词典>scuffing翻译和用法

scuffing

英 [ˈskʌfɪŋ]

美 [ˈskʌfɪŋ]

v.  磨损; 磨坏; 拖着脚走
scuff的现在分词

现在分词:scuffing 

柯林斯词典

  • V-ERG (使)磨损;(使)磨坏
    If youscuffsomething or if itscuffs, you mark the surface by scraping it against other things or by scraping other things against it.
    1. Constant wheelchair use will scuff almost any floor surface...
      任何地板上经常有轮椅走动几乎都会有所磨损。
    2. Molded plastic is almost indestructible, but scuffs easily.
      注塑几乎弄不坏,但是容易磨损。
  • VERB 拖着脚走
    If youscuffyour feet, you pull them along the ground as you walk.
    1. Polly, bewildered and embarrassed, dropped her head and scuffed her feet.
      波莉既困惑又尴尬,低下头拖着脚走开了。

双语例句

  • She's always scuffing her shoes in the playground.
    她总是在操场上磨损鞋子。
  • The experimental results showed there exists influence of the oil temperature on the scuffing resistant.
    试验结果表明:供油温度对摩擦副的抗咬死性能有较大的影响。
  • To study the scuffing mechanism of sliding friction pairs adopting the time changing idea will be more practical.
    对摩擦副咬死的研究应考虑润滑油中磨粒随时间改变的因素,基于时变的观点来研究摩擦副咬死机理更具有实际意义。
  • At the end of the service, King paraded up the aisle with the choir, his robe scuffing the floor.
    在仪式要结束时,金与唱诗班列队走上了过道,他的长袍拖到了地板。
  • The research method adopted in the paper are fo some significance to the study of gear scuffing mechanism and the study to increase the gear scuffing load carry capacity.
    本文的研究方法对齿轮胶合机理和提高齿轮胶合承载能力的研究都是有意义的。
  • The anti scuffing, friction reducing and wear resistant properties were investigated systematically on a pin on disc tester under engine oil lubrication condition.
    用销盘试验机在机械油润滑条件下对渗硫表面的抗擦伤性能,减摩及耐磨性能进行了系统研究。
  • The mould test demonstrates that the surface scuffing and metal transferring can be greatly deduced at dry friction condition.
    模具试验表明,复合镀层有效地降低了干摩擦状态下注塑模推管与摩擦件的表面划伤与金属转移。
  • Effect of Lubricating Oil Temperature on Gear's Scuffing Resistance
    润滑油温度对齿轮胶合承载能力的影响
  • The temperature effect of scuffing in sliding contact of steel is explored from the point of view of frictional temperature.
    作者从摩擦温度的观点考察了钢在滑动接触中擦伤的温度效应。擦伤试验是在环-块试验机上进行的。
  • The maximum load on a bearing should always be smaller than the relief load in order to avoid scuffing.
    为了避免划伤,轴承上的最大负荷应该总是小于其卸载负荷。