planeness

英

美

网络  平面度; 平整度; 平面度,平整度

化学

英英释义

noun

• the property of having two dimensions
  Synonym:two-dimensionalityflatness

双语例句

• Based on these, optimum-searching method, a new method for calculating error in planeness by a computer with optimization technique is given.
  在此基础上，利用最优化技术，提出一种在计算机上计算平面度误差的新方法&寻优法。
• The conclusion that the sensor can realize measurement of planeness is obtained according to the experimental studies and theoretical analysis.
  通过对该传感器进行实验研究和理论分析，给出了这种电容传感器可实现平面度测量的结论。
• Evaluation for Urban Road Planeness Index& Its Abnormal Analysis
  城市道路平整度指标的评价和引起异常的分析
• Quality Control of Planeness in New Spacecraft Solar Wing Substrate
  新型航天器刚性太阳电池翼基板的平面度品质控制
• The paper analyses the factors influencing the planeness of asphalt concrete pavement from highway roadbed, spreading material of surface layer, roller compaction and bridge culvert. It also presents the corresponding preventive measures.
  从公路路基、路面基层、面层摊铺材料、碾压及桥梁涵洞等方面分析了可能影响沥青砼路面平整度的因素，并提出了相应的预防措施。
• This is needed for planeness error calculation. Motion control was studied. By mechanical and control system design a combined motion control mode was mad.
  对测量系统进行了运动控制学研究，采用了位置控制与力控制相结合的组合控制方案，并设计出充分体现这一控制思想的机械结构和控制系统，实现了测量系统的自动行走与测量。
• Through auther's engineering practice in recent years, analyses the influence factors of pavement planeness and put forward the homologous counterplan, thus insuring the high grade highway asphalt concrete pavement planeness.
  笔者通过近年来的工程实践，分析了影响公路平整度的因素，并提出了相应的对策，从而确保高等级公路沥青混凝土路面的平整度。
• The paper analyses the influence of the construction craft of asphalt concrete coating on pavement planeness, and proposes several methods to improve the pavement planeness.
  分析了沥青混凝土面层施工工艺对路面平整度的影响，并就如何提高路面平整度提出了一些处理方法。
• The Handing of Measured Data for Planeness Error With the Aid of Microcomputer
  用微型计算机处理平面度误差的测量数据
• During each day's capping operation, check the planeness of the caps prior to compression testing on at least three specimens, selected at random, representing the start, middle, and end of the run.
  每天的压顶操作中，在进行抗压试验前，应对至少三个试样上压板的平面度进行检查，这些试样是随机抽取的，分别代表操作开始、中间和结束时所用的试样。